IAR J-Trace

Trace probe for ARM
 
(Part Number: JTRACE-ARM-2M)
 
IAR J-Trace for ARM
IAR J-Trace—trace device for ARM processors
 
IAR J-Trace for ARM is a high speed hardware trace probe for ARM; it connects via USB to the PC host running Windows. IAR J-Trace integrates seamlessly into IAR Embedded Workbench and is fully plug-and-play compatible, and in addition very easy to use.

General features
  • USB-driven JTAG and Trace (38-pin Mictor) interface
  • Supports all ARM7 and ARM9 devices.
  • No power supply required, powered through USB, although external power supply plug is available
  • JTAG speed 12 MHz
  • Auto speed recognition
  • USB-2 full speed (12Mbit/sec)
  • Adaptive clock based on RTCK JTAG signal
  • All signals can be monitored, target voltage can be measured
  • 20-pin standard JTAG connector, 38-pin standard Trace Mictor connector
  • USB, 20-pin flat cable and 38-pin trace cable included
  • Full integration with the C-SPY Debugger; advanced debugging features available from C-SPY.
  • Integration into IAR Embedded Workbench for ARM makes setup and use easy

  • Supported platforms: Windows 2000 and Windows XP

Trace features
  • Trace supports up to 200 MHz full and 100 MHz half clock rate
  • Trace based on ARM ETM (Embedded Trace Macrocell)
  • Trace support for devices with built-in trace ports
  • 2 Mbyte trace memory buffer
  • Compact housing, fits easily on the desk
  • Silent, fanless design

  • Support for cycle accurate and compressed tracing

  • Supports 4 / 8 / 16 bit trace port at both full and half-rate clocking
  • Trace window synchronizes to source and disassembly window
  • Function trace shows called functions hierarchically

  Back to IAR Home Page    Back to Testech Home Page   Compiler     RTOS    Emulator/Debugging