Electronic
Displays
Streetside
Displays
Installation costs for wiring streetside displays can be very costly when considering trenching and weatherproof cabling to complete the job. As a lower cost solution, MaxStream radio modems are used to make the data communication link between the controlling PC and the streetside display.
The data which has to be displayed is received from a separate system which is usually located in a convenience store or fuel pump office. A serial bus is used for the communication between the two devices.
Out-of-the-box functional solution
MaxStream radio modems provide serial communications in an out-of-the-box functional solution, simplifying integration for the system designer and the field technician installing the system. No RF experience is needed to implement this solution.
Live Data
Streaming
Displays
We are truly
living in
the age of
information.
But not all
information
is created
equal when
it comes to
critical
information.
When it is
received and
where it is
displayed is
just as
important as
the content
of the
information
itself.
Cut the wires and put that information...in plain sight
MaxStream's 9XStream stand-alone radio modems enable consumers of mission critical, real time, streaming financial market information to cut the wires and put that information where they need it… in plain sight.
It
used to be
that the
live data
feed of
market
information
appeared on
a PC that
was
subscribed
to the
information
server.
Then an
improvement
was made,
that
information
could be
displayed on
a monitor
that was
hard wired
to that same
PC. But
special care
had to be
taken to
assure the
correct
wiring was
installed
during the
construction
of the
building.
If that
monitor was
to be
installed
after
initial
construction,
wiring would
need to be
strung
through an
existing
building.
The options were to tear out the walls and start over, or run conduit and unsightly wires to connect the monitor. Not bad if you're in a warehouse, but what about an office environment? And after all of that, the monitor still had to be in same vicinity at the PC.
To accomplish this task, all you need to do is plug a 9XStream-PKG into the PC with the live data feed, and another 9XStream-PKG directly into the monitor itself, and you're done. This is not just a single monitor solution; you can broadcast that information to as many sites as you wish (within range), either individually, as groups, or all at once.
So cut the wires and display information mission critical information when and where you need it, to one point or multiple points. With MaxStream's 9xStream PKG, there is no construction or remodel costs, no need to run special network cables, only live data.