LPC-E2294 DEVELOPMENT PROTOTYPE BOARD WITH USB, 4x CAN, RS232, ETHERNET
 

FEATURES:

• MCU: LPC2294 16/32 bit ARM7TDMI-S™t with 256K Bytes Program Flash, 16K Bytes RAM, EXTERNAL MEMORY BUS, RTC,4x 10 bit ADC 2.44 uS, 2x UARTs, 4x CAN, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
• standard JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG
• 1MB (256Kx32bit) 12 ns 71V416 SRAM
• 4MB (512Kx16bit) 70ns TE28F320C3BD70 C3 INTEL FLASH
• standard JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG
• USB to RS232 convertor, board can take power only from USB port
• 4 CAN drivers and connectors
• RESET circuit with exterman control of Philips ISP utility via USB-RS232 virtual port
• Jumpers for boot select from external memory
• Jumpers for ISP/RUN mode
• Ethernet controller with CS8900A and RJ45 connector
• LCD 16x2 DISPLAY with BACKLIGHT
• 2 BUTTONS
• POTENTIOMETER connected to AIN0
• SPI connector
• RS232 driver and connector
• DALLAS i-BUTTON interface and connector
• I2C 24LC515 EEPROM on board
• two on board voltage regulators 1.8V and 3.3V with up to 800mA current

   

    Back to Olimex Main Page    |    Back to Testech Home Page    |    Compiler    |     RTOS    |    Emulator/Debugging